Innotech Genesis V4 System Manuel d'utilisateur télécharger pdf (Page 38)

Installation Instructions for Innotech Genesis Systems

Edition 011100

3-12

NOTE

Two terminals, located between the Digital and Analogue Input

terminal groups (Figure 3-4), are provided for terminating cable

screens.

3-3.2.5. Analogue Outputs. The Genesis II MPC’s analogue output wiring

information is similar to that of the Genesis II Digital Controller (refer to Paragraph 3-

3.1.5), with the following exceptions:

• The MPC only uses four analogue output channels: AO1 through AO4.

• Terminal numbers are not assigned, however terminals are clearly labeled as to signal

name: The two centre terminals of the group of six analogue output terminals are the

signal return (Common) connection points.

3-3.3. GENESIS I DIGITAL CONTROLLER. Figure 3-5 shows the input/output

connection groups for the Genesis I Digital Controller. The controller uses Phoenix type plug-

in terminal strips located around the controller’s perimeter. Terminals are grouped by function

as follows:

• Power – Same as for Genesis II Digital Controller; see Paragraph 3-3.1.1.

• Digital Inputs – Same as for Genesis II Digital Controller; see Paragraph 3-3.1.2.

• Digital Outputs (Paragraph 3-3.3.1)

• Analogue Inputs (Paragraph 3-3.3.2)

• Analogue Outputs (Paragraph 3-3.3.3)

• Local Expansion Module (LEM) Connector (Paragraph 3-3.3.4)

• RS485 Comms Terminals (Appendix A)

• RS23

1011121314151617183456789192028293031323334353621222324252627

4850515354565759606263414244454778656667686970778990919293

24Vac POWERSCREENSDIGITAL INPUTSANALOGUE INPUTS

ANALOGUEOUTPUTSRS485COMMSRS232CONNECTORDIGITALOUTPUTS

LEM

CONNE

CTOR

2 Connector (Appendix A)

3-3.3.1. Digital Outputs. The Genesis I Digital Controller’s digital output wiring

information is similar to that of the Genesis II Digital Controller (refer to Paragraph 3-

3.1.3), except that the NC output relay contacts are not used. Only the C and NO contacts

of the eight digital output relays are represented at the output terminals. Refer to Table 3-7.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 114 115

Pas de commentaire

Innotech Genesis V4 System Manuel d'utilisateur Page 38