Innotech Genesis II Digital Controller (v5) Manuel d'utilisateur télécharger pdf (Page 14)

Genesis II Installation Instructions

Page 14 © Mass Electronics Pty Ltd 2010Edition 2.0 dated 06/12/2013

1-2 Special Considerations

The following precautions and installation considerations must be observed to ensure personal

safety and to prevent damage to equipment:

• Local safety regulations, building codes and ordinances must be complied with during

installation. In cases of conflict with procedures in this manual, contact Innotech or its authorised

representative for clarification.

• To prevent damage to equipment, avoid applying electrical power to the equipment prior to

checkout, unless specifically instructed to do so in this manual.

• The Genesis II System can be installed using common tools and test equipment. Only qualified

personnel familiar with local codes and practices should install the system. Wiring should only be

performed by someone knowledgeable of electronics and wiring installation practices. Refer to

the appropriate documentation when installing items provided by other manufacturers.

1-3 Unpacking Instructions

The following unpacking instructions should be followed as soon as possible aer the equipment is

delivered to the installation site:

1. Carefully unpack each item and set packing materials aside for future use.

2. Check the inventory against the packing list to make sure nothing is missing.

3. Inspect each item for damage.

4. Report any shortages or damaged items.

5. Collect all factory inspection sheets and similar data; place in an equipment history file.

6. Any items which are not installed immediately should be carefully returned to its shipping

container and stored in a safe place until it is time for it to be installed.

1-4 Installation Plans

The following installation data should be gathered and made available to the installation team:

• This technical manual.

• Computer-Generated Wiring Diagram: the Innotech Gen2Config soware can be used to print a

wiring diagram for the specific application. A copy of this wiring diagram is usually provided at

the time of hardware delivery. Procedures for printing additional copies of the wiring diagram are

contained in the Gen2Config Online Help.

• Computer-Generated Materials List: the Materials List is also provided at the time of hardware

delivery. The list is printed out from the Innotech Gen2Config soware. The Materials List shows

all the items of hardware required for the specific application.

• For non-Innotech equipment, gather the manufacturer’s installation-related data such as

schematics, wiring diagrams, dimension diagrams, etc.

• Any other data source as it becomes known.

1-5 Tools and Test Equipment

No special tools are required for installation of the Genesis II Systems. Only common hand tools

are needed. A high impedance digital Volt-Ohm-Milliammeter is the only item of electronic test

equipment required.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 123 124

Pas de commentaire

Innotech Genesis II Digital Controller (v5) Manuel d'utilisateur Page 14