Genesis II Installation Instructions
Page 92 © Mass Electronics Pty Ltd 2010Edition 2.0 dated 06/12/2013
4-1.4.1 Address Jumpers
Locations and settings of address jumpers are shown on the computer-generated wiring diagram
provided with the system hardware. Figure 4-6 shows a portion of a typical computer-generated
wiring diagram. Address jumper connectors are A0, A1, A2 and A3. Open jumper connectors are
shown in grey on the wiring diagram. Connectors shown in black require a jumper to be installed.
Address jumpers must be properly set on all REMs except for those which are wireless in order for the
system to operate correctly.
1 2 3
JIHGFE
DCBA
AI 5 A I6 AI7 AI8 AI 9
+
+
+
+
+
-----
Sensor #7
Sensor #1 1
Sensor #10
Sensor #9
Sensor #8
Address
jumpers
A0
A1
A1
<not used>
A2
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
JUMPER
OPEN
PORTION OF COMPUTER-GENERATED WIRING
DIAGRAM SHOWING ANALOGUE INPUT MODULE
Figure 4-6: Address Jumpers, Typical Settings
Commentaires sur ces manuels