Innotech Genesis II Digital Controller (v5) Manuel d'utilisateur télécharger pdf (Page 95)

Page 95

Genesis II Installation Instructions

4-1.4.4 Frequency Jumpers

The GENII WMI Wireless Module Interface provides an interface to the SENRx series of wireless

temperature sensors. There are four user selectable frequency jumpers for configuration. To enable

correct communication over a wireless frequency, the settings of these jumpers must be matched.

Locations and settings of frequency jumpers a fare shown on the datasheets for each of these

products. Figure 4-9 shows a portion of a the GENII WMI datasheet, and Figure 4-10 shows an image

of the SENRx series of wireless temperature sensors.

Frequency jumper connectors are F0, F1, F2 and F3. Frequency jumpers must be set properly on all

wireless REMs.

Figure 4-9: Setting Frequency Jumpers on the GENII WMI

Figure 4-10: Setting Frequency Jumpers on the SENRx Module

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 123 124

Pas de commentaire

Innotech Genesis II Digital Controller (v5) Manuel d'utilisateur Page 95