Innotech Genesis II Digital Controller (v5) Manuel d'utilisateur télécharger pdf (Page 96)

Genesis II Installation Instructions

Page 96 © Mass Electronics Pty Ltd 2010Edition 2.0 dated 06/12/2013

4-1.5 Load Soware and Configure the Controller(s)

The Innotech configuration soware program was prepared for your Genesis System at the factory

before delivery of the system. The soware contains all the data for internally configuring the

controller(s) to perform the specific functions for which it was intended. Until the controller is

configured, it can not accept input signals or produce outputs.

To configure the controller(s), a Windows-based PC and the applicable version of the Innotech

Gen2Config program are required. A soware disk is provided with the Genesis hardware at delivery.

The disk contains a program called Gen2Works, which is a collection of several Innotech programs,

including Gen2Config. The other soware programs supplied in Gen2Works are for the purpose of

enhancing operation and de-bugging of the system. But it is the Gen2Config soware that is required

for commissioning the system.

4-1.5.1 - Loading Gen2Works contains instructions for loading the Gen2Works soware into your PC.

4-1.5.2 - Configuring a Controller explains how to configure the controller using the Gen2Config

program.

• The instructions in the next two paragraphs are generalised procedures based on the assumption the operator is

familiar with operation of a PC in a Windows environment.

• Loading the Gen2Works soware requires entry of an Activation Key. The Activation Key is a password provided

by Innotech to permit access to the Gen2Works soware. If an Activation Key has not been provided, contact

Innotech Control Systems at the contact details shown on the last page of this manual. Note that the Activation

Key is only eective for one session. If Setup is to be run at a later date, a new Activation Key is required.

NOTE

4-1.5.1 Loading Gen2Works

To load Gen2Works into the PC:

1. Insert the Gen2Works CD 1 into the appropriate CD or DVD drive.

2. Windows auto run should start the installation process or open the Windows explorer dialog in

the location of the CD, from here select setup. If however the auto run does not open the CD go

to step 3 otherwise skip it.

3. Click on Run and type “<CD Drive Letter>:\setup” (where the drive letter is which ever letter

corresponds to your PC’s CD drive e.g. “D”) in the Run dialogue box, then click on OK.

4. Gen2Works will display a Product Activation dialogue box with a block requesting entry of the

Activation Key.

5. Enter the Activation Key, then click OK.

6. The Gen2Works soware will begin to load. Follow instructions on the screen to complete the

installation process.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 123 124

Pas de commentaire

Innotech Genesis II Digital Controller (v5) Manuel d'utilisateur Page 96