search

Innotech Genesis II Digital Controller (v5) Manuel d'utilisateur Page 81

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 124
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 80
Page 81
Genesis II Installation Instructions
© Mass Electronics Pty Ltd 2010Chapter 4 – Commissioning
10
11 12
13
14
15 16
17
18
3
4
56
7
89
AC
SOURCE
DC
SOURCE
JUMPER WIRE
V
AC
V DC
24V
+
-
V
AC
V DC
24V
+
-
CHECKING DC SOURCE CHECKING AC SOURCE
DIGITAL CONTROLLER
1
2
5. With the voltmeter still connected, manually close the input contacts. If it is not possible to
close the circuit manually, connect a jumper wire across the contacts at the switching device, as
shown in Figure 4-2.
6. Ensure the voltmeter indicates the proper signal voltage as listed in Table 4-2.
7. Ensure that the voltmeter indicates the correct polarity. The unit will not operate properly if the
signal polarity is incorrect.
8. Release the manually closed contacts or remove the temporary jumper from the switch
contacts.
9. Repeat Steps 3 through 7 for the remaining digital input channels.
Avoid risk of electrical shock observe all local electrical safety requirements when performing the nest step.
CAUTION
Figure 4-2:  Checking Digital Input Wiring
Vue de la page 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 123 124

Commentaires sur ces manuels

Pas de commentaire
  • Vocalist Elevation Audio AudioSonic Avancer K-array
  • LG Refroidisseurs de vin Mitel Non Hamilton Beach Accessoires pour la préparation du café Euro Cuisine Petits appareils de cuisine ClearSounds Téléphones
  • Electrolux ESL4550RO Roberts MP-23 Samsung GT-S5360 LG LH-W5100 Melissa 671-105
  • Sony DSC-H2 Manuel de l'utilisateur Hp EliteBook 8470p Notebook PC Manuel de l'utilisateur Bosch SHS5AV55UC Manuel de service Samsung RT53MAEW Manuel de l'utilisateur Toshiba Satellite L50T-B Manuel de l'utilisateur